[Elecraft] Re: K3 CW-in-SSB mode: force CW VOX?

[Don Nesbitt]

As long as it does NOT force VOX to ON when NOT in SSB Mode but in CW Mode
with CONFIG::CW WGHT set to SSB+CW.  If it did, you would always have to
enter the "TEST" mode to key CW without RF being produced.

Additionally, perhaps we should have a menu choice in terms of invoking
forcing CW VOX to ON when in SSB with CW WGHT set to SSB+CW.  Folks with QSK
amps might just like it the way it is.  --Don N4HH

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of wayne burdick
Sent: Monday, June 09, 2008 12:34 PM
To: Elecraft Reflector
Subject: [Elecraft] Re: K3 CW-in-SSB mode: force CW VOX?

Joe,

I'm OK with this if there are no serious objections to it. It's an easy 
firmware change.

73,
Wayne
N6KR

> Joe Subich, W4TV wrote:
>
> > They only suggestion I would make for the firmware is to force
> > CW VOX ON while in SSB mode if "Auto CW" is enabled.  I generally
> > prefer PTT mode for both CW and SSB but it would be handy to
> > override CW PTT if Auto CW was enabled.


---

http://www.elecraft.com

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
No virus found in this incoming message.
Checked by AVG. 
Version: 8.0.100 / Virus Database: 270.1.0/1492 - Release Date: 6/9/2008
10:29 AM