FW: [Elecraft] K3 Beta Firmware Revision 2.02

[Tom Doligalski]

-----Original Message-----
From: Tom Doligalski [mailto:w4kx at nc.rr.com] 
Sent: Sunday, June 08, 2008 7:29 AM
To: 'Dave G4AON'
Subject: RE: [Elecraft] K3 Beta Firmware Revision 2.02

I think you'll find that Channel Hopping on the K3 will work just as you
wish.... try this:

1. Load your frequencies in consecutive memory channels, being sure to use
the asterisk "*" text label.
2. Recall any one of these using M>V.
3. Now, just use VFO A to cycle through your consecutive frequencies... 

73, Tom W4KX

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Dave G4AON
Sent: Sunday, June 08, 2008 2:08 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Beta Firmware Revision 2.02

"Channel hopping" doesn't seem to offer anything useful to me. It would have
been nice if rotating VFO A not only displayed the frequency stored but
instantly assigned it to a VFO so the K3 could be used in the same manner as
a crystal controlled transceiver (without having to press M-V again). As the
K3 lacks a V/M switch, I guess it will not operate in a channelised manner
any time soon.

73 Dave
K3/100 #80
----------------

K3 beta-test firmware revision 2.02 is now available. It includes one new
feature (channel hopping, especially useful on 60 meters) and a correction
to CW/VOX behavior.
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com