[Elecraft] K3 help

[nn5g]

I am on page 55 of the K3 Assembly manual and everything has gone fine until
now. I am putting the bottom covers on and am unable to get the back cover
on properly. The problem is properly installing the ¼” Black pan screws
(with tooth lock washer) over the three power transistors. The screws are
apparently to short as things stand. I can’t even get them to begin
threading. The transistors have ¼” standoffs under the transistor screw
holes. I am overlooking simple I am sure.

The remaining stanoffs on the RF board that attach to the bottom cover are
¼” and have tooth lock washers. HELP!!! Paul NN5G


-- 
View this message in context: http://www.nabble.com/K3-help-tp17713797p17713797.html
Sent from the Elecraft mailing list archive at Nabble.com.