[Elecraft] Re: [K3] K3 and Logger32 logging program

[a yoshida]

Good spot Hank.

The help file will be revised in next version.

Thanks

73 de aki  ja1nlx

----- Original Message ----- 
From: "hank k8dd" <hrkohl at yahoo.com>
To: "Elecraft Reflector" <Elecraft at mailman.qth.net>
Sent: Sunday, June 08, 2008 4:55 AM
Subject: [K3] K3 and Logger32 logging program


If you click on a DX spot, or type in the frequency to change to another 
band and / or mode and the filters do not switch to the default settings 
....
And you are using Logger32 ----- Here is the answer to get SSB settings on 
SSB, Data settings on Data and CW settings on CW sent to the K3!

In the help file there is a section on the K3, but that is for pre-MCU 2.00.
Here is an update to how it works for MCU 2.00 and above:

Filter selection
The K2 and K3 should always store those filter setting by each mode. If you 
select the mode by manually or
clicking DX spot then in the future  they will select the filter by stored 
setting.
There is another way to select a filter directly from Logger32. Add one or 
two of the following section in
the Logger32.ini. “n” in FW0000n is Filter number of your K2.  FWnnnn is 
the DSP bandwidth on your K3 (see
examples below).  The K3 will select the proper first IF (roofing) filter.

For radio 1 (Elecraft) put following lines (Sample for K3)

For K3 below MCU Firmware 2.00
    [Elecraft Filter 1]             # This is for Radio 1
    USB=K22; FW00001;               # K22; puts the K2 or K3 in 'extended 
mode;  FW0000x sets the filter to FLx
    LSB=K22; FW00001;
    RTTY=K22; FW00002;
    CW=K22; FW00002;
For K3 MCU Firmware 2.00 and above
    [Elecraft Filter 1]                            This is for Radio 1
    USB=K31;FW0270;FW0270;         # K31; puts the K3 in 'extended mode' 
FW0270; is 2700 Hz for the DSP filter
    LSB=K31;FW0260;FW0260;         # K31; puts the K3 in 'extended mode' 
FW0260; is 2600 Hz for the DSP filter
    RTTY=K31;FW0100;FW0100;        # K31; puts the K3 in 'extended mode' 
FW0100; is 1000 Hz for the DSP filter
    CW=K31;FW0070;FW0070;          # K31; puts the K3 in 'extended mode' 
FW0070; is 700 Hz for the DSP filter

K3 DSP filter is set to the closest lower 50 Hz.  i.e. FW0069; will default 
to 650 Hz.

For radio 2 (Elecraft) put following lines (Sample for K2).
    [Elecraft Filter 2]            # This is for Radio 2
    USB=K22; FW00001;
    LSB=K22; FW00002;
    RTTY=K22; FW00003;
    CW=K22; FW00004;

You may need to repeat the command for certain filter selections, especially 
in K3.
    CW=K22; FW00002; FW00002;


 -- 
'Never argue with an idiot. They drag you down to their
level then beat you with experience.' -anon
--