[Elecraft] K2 - signal loss in band-pass filter

[Are LB3SA]

My 8V is as low as yours Kristinn but I do not have the same problem. This
leads me to think that you have another problem...  In fact, I am quite sure
- especially since you're not able to see all LED's with RF-Gain nor signal
input. Have you EVER seen the LED's on the far right lit?

I would check the soldering around the LED array.

Are - LB3SA


TF3KX wrote:
> 
> Well, I agree that the basic receiving performance of the rig may not be
> significantly affected, or even noticed at all.
> 
> But in my case I am not able to set the range of the S-meter properly,
> which I attribute to the low 8V level.  My S-meter can not be adjusted to
> turn all LEDs off when no signal is present, and I do not get the S-meter
> quite up to full scale when the RF gain is turned fully CCW.
> 
> If I am correct, this is due to the low 8V and that would be an incentive
> to get that voltage fixed.
> 

-- 
View this message in context: http://www.nabble.com/K2---signal-loss-in-band-pass-filter-tp17294418p17691603.html
Sent from the Elecraft mailing list archive at Nabble.com.