[Elecraft] K3 Band change / mode changes

[David Wilburn]

Is it possible to work from the VFO, and not have to change modes 
every time I switch bands?  The only work around I have found is to go 
through all the bands and set them to what I am working on at the 
moment.  I understand the K2 is the same way, and it bothered me there 
also.  I'm not trying to get into another band stacking register thing 
discussion.

If I have a certain setup in front of me on the rig, just because I 
change frequencies, does not mean that I want to change other settings.

I have looked through the manual and the config menu and I cannot find 
anything applicable.

Being a newer ham, licensed in 2001, I do not recall this happening on 
other rigs.  All I have had before the K2/K3 was a Kenwood TS-570DG, 
and an IC-718, so it is possible that this is like this for a good 
reason, that I am just missing.
-- 


Dave Wilburn
K4DGW
K2/100 - S/N 5982
K3/100 - S/N 766