[Elecraft] VFO's A/B switching between bands

[David Wilburn]

Is it possible to set VFO A to one band, and VFO B to a second band? 
I recall some discussion about this in the past, but do not remember 
if it was on a tudo list, or if it will be a limitation.

As an example, place VFO A on the 20m band CW mode, and VFO B at a 
location on the 40m band CW mode.  I have done this with other rigs, 
is there a menu setting I am missing, or a limitation of the rig?  I 
just did a couple of quick searches through the documentation, but I 
did not see a reference to it.

I am using the 2.20 firmware.  I see that it is supported with the 
sub-receiver.

It is handy during a contest to set VFO B to another band, and bounce 
there periodically to check activity / propagation, while CQ'ing.

-- 
David Wilburn
K4DGW