[Elecraft] K3 Beta Firmware Release, Rev. 2.22

[wayne burdick]

K3 beta-test firmware revision 2.22 is now available. Details appear 
below.

For instructions on how to load beta firmware, please see:

   http://www.elecraft.com/K3/k3_software.htm

73,
Wayne
N6KR

* * *

MCU 2.22 / DSP 1.88, 7-28-08

- CHANNEL SCAN no longer locks out small encoders (during scan or after 
stopping it). (Channel scanning is most often used on 60 meters; refer 
to the owner's manual for details.)

- USER-DEFINED “NORM” VALUES are now referred to as "NORM1/2" rather 
than "ALT1/2" to avoid confusion with the “ALT” switch (alternate 
mode).

- FLASH MEMORY INITIALIZATION corrected to prevent spurious “FPF LOAD 
PENDING” messages. If this message does appear unexpectedly, tap any 
switch to see the flash read exception code, e.g. “FPF 1”. Report this 
to customer support.


---

http://www.elecraft.com