[Elecraft] Help with PSK

[Greg - AB7R]

Tom,

For now, the only way to run PSK-D is with the paddles connected to the paddle input on the 
K3, or using a terminal, such as the one on the K3 Utility program.  If you are using 
soundcard software for PSK you need to HOLD DATA MD (AFX button) and select DATA-A using the 
VFO B knob.  Do that and set up your output per the K3 Operating Tips page and you should be 
good to go.  When in Data mode the CMP is automatically clamped down a zero.

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065


On Tue Jul 29  4:35 , Tom Wylie  sent:

>I am trying (and failing miserably) to set up my K3 to work PSK31 mode.
>
>I am using a Microham USB Microkeyer II and my normal Logger 32 software 
>which I have used for aged with my MP running very fb.
>
>The outgoing tones from my K3 dont "sound right" and a near neighbour 
>says my signal is very bad
>unreadable and very broad.
>
>In the K3,   I have the compression set to 0  the mike gain set to 0.  I 
>am in Data mode   and using DATA MD have    PSK  D showing -  31 bps.....
>
>My K3 ALC meter is still showing almost full ALC (according to the 
>meter) with almost now poer output (turned right down).
>I have the TX knob on my Microkeyer set at zero and within Logger 
>soundcard - psk window, have the output set right back, well below the 
>settings for the MP!
>
>I am receiving PSK no problem at all.     The radio is connected to my 
>computer via the serial port on the rear...
>
>I can run RTTY FSK without any problem whatsoever.
>
>I think i need a little guidance here...
>
>Tom
>GM4FDM
>
>
>-- 
>So I met the bloke who invented crosswords today. I can't remember his
>name, it's P something T something R.
>
>
>
>---
>avast! Antivirus: Outbound message clean.
>Virus Database (VPS): 080728-0, 28/07/2008
>Tested on: 29/07/2008 12:35:55
>avast! - copyright (c) 1988-2008 ALWIL Software.
>http://www.avast.com
>
>
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com