[Elecraft] KXV3 board questions

Brett Howard brett at livecomputers.com
Sat Jul 26 15:38:20 EDT 2008


On Sat, 2008-07-26 at 11:01 -0400, Jack Colson wrote:
> Just installed the KXV3 board this morning and have observed the 
> following:
> 1) the RX ant works - what is the RX ant OUT for?
> 
I believe that you can use it for feeding your signals through a preamp.
I used it a while back for doing A/B comparisons of rigs.  I set the
other rig to 0Watts out then I connected the output of that rig to RX
out.  Then hooked the antenna up to RX ANT.  Then I could tune both rigs
to a signal and then quickly switch between the two and do comparisons.
The K3 compared favoribly to my TS450 but heck I knew the TS450 was a
noisy son of a gun once I got my K1!

> 2) in the Config menu for the KXV3 get only these three options - nor, 
> not installed and EESE.
> 

That actually says tESt

> 3) in the config WMTR mode, will only go to HP and VFO A just varies a 
> number from 0-100, no option for LP or MW
> 

If you simply turn your power below 12 watts you'll get WMTR LP.  Then
to get to the MW setting you need to put your KXV3 into tESt mode.
Check page 46 ofyour owners manual.

> 4) observed the transverter out and in with an oscilloscope and when in 
> cw mode and key rig all I see is differentiated spikes.

Were you in a transverter band?
> 
> I went through the transverter set up menu as well.  That seems to agree 
> with the manual.
> 
> Any suggestions?
> 
> Thank you,
> 
> Jack, W3TMZ
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com



More information about the Elecraft mailing list