[Elecraft] K3 died while attempting firmware download

[Chad WE9V]

The radio is in a state where it's waiting for you to load software.
Either try the same version, or back up a version or two and put that
in.  Make sure that your serial cable is plugged in properly before
beginning.

Chad WE9V

On Fri, Jul 25, 2008 at 11:58 AM, Gary Nichols <kd9sv at comcast.net> wrote:
> Help please.I killed w8uvz's K3 while trying to download current firmware.
> The computer attempted to download three times and then became
> non-responsive.  I could not power down the K3 so I turned off the power
> supply.  When re-applying power the TX light is blinking and only MCU LD
> appears on the screen without backlighting.  How do I get back to a working
> radio from here?  Thanks, de gary, kd9sv
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>