[Elecraft] K3 KXV3 Installation

[Brett Howard]

I noted no problems at all on my KXV3 installation.  Went in smooth as silk.

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of ab2tc
Sent: Wednesday, July 23, 2008 5:31 PM
To: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 KXV3 Installation


IHi Mike,

I had this problem, but after endless fiddling I managed to sneak the board
into place without cutting any pins. It *is* difficult and Elecraft ought to
do something about it.

Knut - AB2TC



Mike Downs-2 wrote:
> 
> I just finished installing the KXV3 option in my K3. Everything went  
> smoothly until I got to the step on page 10 where you plug the KXV3  
> board into J66. The instructions say the pins will just barely clear  
> the top of J66. Well, try as I might I couldn't get the pins to clear  
> the top of J66. So I clipped off the tips of the pins until they  
> cleared J66 and I could plug the KXV3 board into J66. Anyone else have  
> this problem? If so, Elecraft may want to add something to this effect  
> to the installation instructions.
> 
> Mike, ks7d
> 
> <snip>
> 


-----
AB2TC - Knut
-- 
View this message in context:
http://n2.nabble.com/K3-KXV3-Installation-tp579465p579553.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com