[Elecraft] Firmware Beta 2.19

[Phillip Buckholdt]

Hi Don, Lyle and Vic

In v2.16 I had slope set to 15 and Threshold set to 5.

I reloaded v2.19 and to get audio level up I have set slope to 0 and 
threshold to 8. I have not found any 9++ sigs on 20 just yet.

     73 Phil

----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at embarqmail.com>
To: "Phillip Buckholdt" <k8mby-1 at wadsnet.com>
Cc: "Elecraft List" <elecraft at mailman.qth.net>
Sent: Wednesday, July 23, 2008 1:17 PM
Subject: Re: [Elecraft] Firmware Beta 2.19


> Phil,
>
> I don't notice a change in the audio level on my K3.
> Is there a possibility that you had your AGC set for strong AGC action, 
> and the AGC changes in 2.19/1.87 is creating the difference for you?
> I would suggest reloading MCU 2.19 and DSP 1.87, then adjusting the AGC 
> parameters to suit your preference.  Loading the new firmware does not set 
> the parameters to any default settings, the settings you had before will 
> still be in effect.
>
> 73,
> Don W3FPR
>
> Phillip Buckholdt wrote:
>>   Hi All
>>
>>    I loaded Beta 2.19 and found the audio level decreased. I had to set 
>> AF gain at 12 o'clock for good level and with Beta 2.16 was good at 9 
>> o'clock so, I went back to V 2.16 since most of the other changes were 
>> for the sub receiver. Any one else notice this ?
>>
>>   Phil K8MBY # 609
>>
>
>