[Elecraft] new K1: no transmit on Band 2

[Elwood C. Downey]

Hello everyone,

I am building a K1, 2 band model, 40 and 15m. VFO and Receiver alignment went smoothly on both bands, seems to be a
nice receiver. Transmit alignment went fine on Band 1, measured full 5W to dummy load. But no joy on Band 2. OUT is
set to 2.0 watts but pressing TUNE mode shows P0.1 always. WPM+ and WPM- has no effect. No power at all measured at
dummy load.

Again: receive OK both bands, xmit ok band 1, no power out on band 2.

Suggestions most appreciated.

Thanks in advance.

73,

Elwood Downey, WB0OEW, Socorro NM