[Elecraft] K3: Low power in RTTY
hank k8dd
k8dd at inbox.com
Sun Jul 20 11:36:31 EDT 2008
I got in NAQP RTTY late for an hour or so last night. Only used 20, 40 &
80M and the power was 100 watts out the whole time - at least when I looked
at the wattmeter!
I did watch the PA Temp, after I heard the fans speed up, which made it into
the mid 40's C.
The only problem was the AF Gain was controlling the Line Out to the PC - a
problem with trying to record the contest with both RX and TX signals.
Every time I'd change the AF Gain I had to adjust the Line In level on the
PC! And with =PHONES turned off you can't record the TX side of the QSO.
Kind of a PITA.
Other than that the K3 using 500 Hz (both first IF crystal and second IF
DSP) was a real treat!
73 Hank K8DD
----- Original Message -----
From: "WA6L" <wa6l at arrl.net>
To: <elecraft at mailman.qth.net>
Sent: Sunday, July 20, 2008 10:37 AM
Subject: [Elecraft] K3: Low power in RTTY
>
> I worked for a few hours during the NAQP RTTY contest this weekend and ran
> into a strange issue. On 15 and 20 I get full power out while running
> RTTY
> on the K3. On 40 and 80 I am limited to about 20 watts.
>
> I am running versions 2.02/1.77 of the firmware. I normally run in 'Data
> A'
> mode but tried 'AFSK A' as well. SWR was similar for all bands as was the
> software (Writelog & MMTTY).
>
> I looked at every control and configuration that I could think of that
> might
> be different betwen the bands but couldn't find anything. It may well be
> that I have a setting wrong but I cannot find it. To try and isolate the
> issue I left everything the same except the band button, and still ran
> into
> the problem.
>
> On CW, the power out is consistent between all bands.
>
> Any help would be appreciated. If this is a known firmware issue let me
> know and I will load one of the betas.
>
> Thanks and 73,
>
> John, WA6L
____________________________________________________________
GET FREE 5GB EMAIL - Check out spam free email with many cool features!
Visit http://www.inbox.com/email to find out more!
More information about the Elecraft
mailing list