[Elecraft] RE: [microHAM] MK2R+

[Joe Subich, W4TV]

For Digital modes, MK2R+ uses audio from the Line Out ... audio 
selection is controlled by the RECORDING/DIGITAL controls - not 
the headphone switching matrix.  Be sure you have selected the 
correct (left channel only) audio from K3 in MK2R RECORDING/DIGITAL. 
K3 Line OUT should be set close to NOR with the level about 20.

MK2R should NOT be set for WTY ... MMTTY should be configured 
to use the USB Audio CODEC (check the WAVE IN ID in Router). 

73, 

   ... Joe Subich, W4TV 
       microHAM America 
       http://www.microHAM-USA.com 
       http://groups.yahoo.com/group/microHAM 
       support at microham.com 
 


> -----Original Message-----
> From: microHAM at yahoogroups.com 
> [mailto:microHAM at yahoogroups.com] On Behalf Of Mike Kasrich
> Sent: Saturday, July 19, 2008 8:35 PM
> To: microHAM at yahoogroups.com; Elecraft
> Subject: [microHAM] MK2R+
> 
> 
> Guess Im just stupid but thats the way it goes.  Ive been 
> trying to get MMTTY to work with the mk2r+.  I seem to get 
> xmit ok but cant receive.  The audio comes out the speaker 
> instead going line out the back Im guessing.  Ive changed 
> just about everything that seems audio/speaker related to 
> get the audio where it needs to be w/o luck.
> 
> Any suggestions?
> 
> Mike/aj9c
>