[Elecraft] ERR TXG

[OE5CSP-Chris]

Hi,

Gary from Elecraft gave me an important hint and so the rx of my K3 is now
working.It seems, that if you are using just one filter(I use the standard
5-pole filter) it must be in slot 1.I thought slot 3 would also be  okay,
but it wasn´t.So I thought everything was fine then, until I wanted to do
the low power calibration again.
I couldn´t calibrate my K3 on 30m and above.On some of the bands I had some
output, but on 20 and 12m there was no output at all.
I did the transmit crystal filter selection again. I don´t have an AM filter
installed, but how should I set it(the K3 asks me to do so...)-I can´t
transmit without an Am-filter, can I?
Any ideas?


73, Chris-OE5CSP
-- 
View this message in context: http://n2.nabble.com/ERR-TXG-tp573367p573367.html
Sent from the Elecraft mailing list archive at Nabble.com.