[Elecraft] K3 sub rx audio, etc.

[Tom Childers, N5GE]

On Thu, 17 Jul 2008 12:32:20 -0700, Lyle Johnson <kk7p at wavecable.com> wrote:

>>> If no antenna tuner, must one install the BNC connector?  I don't see ever
>>> needing to connect the sub rx antenna to any but the transmit antenna.   The
>>> firmware makes one choose either BNC or antenna tuner. There is no choice
>>> for none.
>
>This is for specifying the alternate antenna input for the KRX3. Not 
>selecting the alternate antenna input is "none".
>
>I've found all sorts of uses for the BNC that I didn't envision when I 
>installed it.  Since you don't have the KAT3, I encourage you to 
>seriously consider adding the BNC with the KRX3. It comes with the KRX3 
>and only costs another 30 minutes or so in the installation.
>
>I had my KRX3 initially set up with the KAT3.  Later in the development 
>and testing cycle the BNC cable became available, and I installed it.
>
>I'm leaving it with the BNC!
>
>73,
>
>Lyle KK7P
[snip]

Me too, Kyle.  I'm going with the BNC connector...

Tom, N5GE - SWOT 3537 - Grid EM12jq

"Those who would give up 
Essential Liberty to 
purchase a little Temporary 
Safety deserve neither 
Liberty nor Safety" 

An excerpt from a letter 
written in 1755 from the 
Assembly to the Governor 
of Pennsylvania.

Support the entire Constitution, not 
just the parts you like.

http://www.n5ge.com
http://www.eQSL.cc/Member.cfm?N5GE