[Elecraft] WTB: 10-MHz Test Oscillator Wanted

[Alan D. Wilcox]

Don,
The XG1 output isn't enough signal for the scope (and its output, which 
is connected to my freq counter).
No adjustment cap either.

http://www.aade.com/newfreq/new%20freq.htm does have merit. If there's a 
cap in there to
tweak at some future time, then it should do the trick.

Thanks,
Alan--

Alan D. Wilcox, W3DVX
570-321-1516
http://WilcoxEngineering.com
Williamsport, PA 17701 



Don Wilhelm wrote:
> Alan,
>
> Why not just build an XG1 and put a 10 MHz crystal in it - it will 
> only do -73 dBm output as a stock item, but I am certain you could run 
> it through an amplifier.
>
> Of course, there is always the AADE frequency standard that claim 1ppm 
> long term accuracy.
>
> 73,
> Don W3FPR
>
> Alan D. Wilcox wrote:
>> Hello,
>>
>> Want 10-MHz crystal oscillator that puts out a volt or so for 
>> frequency counter calibration check.
>>
>> Must have cap to set freq zeroed onto WWV for a few minutes 
>> operation; no long-term stability required.
>> Something like the XG1 ... battery, BNC, not fancy.
>>
>> Thought this would be simple search ... a kit-builder's project. 
>> Guess nobody's making such a kit.
>>
>> Anybody have or know where to get?
>>
>> Thanks,
>> Alan
>>
>