[Elecraft] K3 --> N1MM Logger

[Joe Subich, W4TV]

WinKey and the K3 can not share the same port. 

N1MM enforces the WinKey settings at 1200 bps (value set does 
not matter) DTR=ON RTS=OFF because the DTR=ON and RTS=OFF are 
required by the stand alone K1EL serial WinKey. 

You must not have any port checked for CW EXCEPT the port 
being used by WinKey. 

73, 

   ... Joe, W4TV 
 
  

> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of 
> john.lyon1 at comcast.net
> Sent: Wednesday, July 16, 2008 11:54 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] K3 --> N1MM Logger
> 
> 
> Hi all,
> 
> I'm having trouble keying the K3 with N1MM Logger. I use 
> MicroHam CW Keyer. It works fine with AC Log, both rig 
> control and CW Keying. The rig control with N1MM Logger works 
> fine. But CW keying doesn't. I have attempted to configure CW 
> as follows: check the CW box, Com port 4800, N, 8, 2. DTR and 
> RTS to Always Off (thought that was the Elecraft preference), 
> and  the Winkey box checked. 
> Sometimes this works, sometimes not.
> 
> Every time I reenter N1MM, it has always been reset to DTR 
> Always On, RTS Alway Off, and Winkey unchecked. 
> 
> Would appreciate a note off line with anyone who has made it work.
> 
> 73,
> 
> John W9LHG
> 
>     
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com