[Elecraft] RE: [dxlab] K3 will keep CW filters when QSYing SSB

[hank k8dd]

I don't see this with Logger32 ..... But I had to add some lines to the .ini 
file
so the program would change the filter to what I specified - 700 Hz on CW, 
2.7 KHz on SSB and 1.0 KHz on Data.
If the program does not tell the K3 how to set the filter when you change 
band and / or mode it will revert to the previous mode and you have to use 
NORM.  At least with the current firmware!

73    Hank    K8DD



> -----Original Message-----
> From: Laurent FERRACCI
>
> Hi friends,
>
> I am posting this message to the Elecraft, microHAM and DXLab lists,
> because all three are involved. Sorry for crossposting. Anyway, it
> probably won't appear in the Elecraft list, because this list
> considers
> me as a spammer (?).
>
> Say i'm listening to CW on my K3, and see a interesting spot on
> Spotcollector. I click on it, Commander and my microKEYER
> will QSY the
> K3 to the spot frequency.
>
> However, i usually end up in SSB with the previous filter setting, ie
> the narrow CW filter, and of course it's not enough for SSB.
> Of course,
> i only have to press the "NORM" button to broaden it, but
> it's annoying.
>
> I don't have the same problem when QSYing from SSB to CW (the
> width is
> reduced as it should).
>
> Has anyone the same problem ? Any advice ?
>
> -- 
> Laurent Ferracci, F1JKJ

____________________________________________________________
GET FREE 5GB EMAIL - Check out spam free email with many cool features!
Visit http://www.inbox.com/email to find out more!