[Elecraft] Re: KAT3 ATU and SPE Expert 1K-FA Amplifier

[Dave G4AON]

Chris

Is this simply an issue of RF being picked up by the antenna connected 
to the output of the linear, which it would see as reverse RF whenever 
you transmit directly from your K3 on another antenna?

Also you can measure the RF from ANT2 when transmitting on ANT1 fairly 
easily... On my K3 with 100 Watts out of  ANT1 I cannot measure anything 
from ANT2, with or without the ATU in use. I tested right up to 50 MHz - 
the lower limit on my power meter is 50 mW.

73 Dave, G4AON
K3/100 #80 & Acom 1000
----------------------------------

My K3 has the KAT3 ATU fitted and I therefore have the options of
selecting ANT 1 and ANT 2. I use the K3 with the SPE Expert 1K-FA
amplifier.

After looking at the diagram showing the switching of the KAT3 in the
K3 Owner's manual, am I right in thinking that when transmitting (I
am a CW operator), there should not be any RF on the antenna not
selected?

I use ANT 1 for all my HF antennas, including 6m, and ANT 2 for a
resonant inverted vee for 60m that I put up yesterday.

The reason I ask the question above is that when I select ANT 2 (for
60m) and transmit, the 1K-FA immediately goes into STANDBY mode
because of a high SWR.

I am wondering if my KAT3 ATU is working properly? With the KAT3 in
BYPASS mode (which is how I have been using it for all my HF
antennas), the K3 SWR meter gives an SWR of 1:1 on 60m, which it
should do as the antenna is resonant.

When I switch the ATU to the AUTO position on 60m with the same
antenna and then tap the ATU TUNE button, the K3 makes a similar
noise to the K2 ATU I have, but does not display any readings. When
I then transmit, the SWR meter shows maximum SWR and about 40 watts
output with the K3 power contrtol set to 100 watts.

I have tested the KAT3 relays using the L1-L8 and C1-C8 and Ct
settings in the KAT3 CONFIG menu and they appear to be working ok.

This is the first time I have needed to use the KAT3 ATU or the ANT
1/ANT 2 facility since I got the K3.

I would appreciate any advice or suggestions, please.

Thanks and 73 de Chris, G4BUE