[Elecraft] [K3] RIT Operation Question

[Bud Semon N7CW]

Brett and Don,

I wasn't really complaining - it just didn't make sense to me.  I should
have remembered to RTFM.  Thanks for reminding me.  Now to figure out how to
use that feature to make working DX easier...

73, Bud  N7CW

-----Original Message-----
From: Brett Howard [mailto:brett at livecomputers.com] 
Sent: Monday, July 14, 2008 8:13 PM
To: w3fpr at arrl.net
Cc: Bud Semon N7CW; elecraft at mailman.qth.net
Subject: Re: [Elecraft] [K3] RIT Operation Question

It should also be noted that holding clr zero's the offset but adds the
offset to the current VFO freq.

On Mon, 2008-07-14 at 23:04 -0400, Don Wilhelm wrote:
> Bud,
> 
> It works just like the manual states.  "Tap CLR to zero the RIT/XIT 
> offset.  Tapping it a second time restores the offset." - see the manual 
> page 22.
> 
> While your comment makes some sense, this is the first time I have heard 
> anyone complain about teh original operation of the CLR control.
> 
> 73,
> Don W3FPR
> 
> Bud Semon N7CW wrote:
> > When I have the RIT on and I press CLR, the RIT is cleared.  So far so
good.
> > When I press CLR again, the original offset reappears.  I would expect
that
> > pressing CLR a second time would just verify the frequency delta is 0.
If I
> > want to switch between an offset and none, I can turn the RIT on and
off.
> > Is there a feature here that I'm missing?
> >
> >   
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com