[Elecraft] K3 ERR TXG

[Dick Grolleman]

Hi All

Just completed my K3 SN:1168 last night. Now doing the calibration I ran into the folling problem. Everything went fine until I did get to the transmitter gain part.
on 160 to 30 m it says ERR TXG. I puts out 1.1 to 3 watts on these bands. On the higher bands it's ok.
I started all over again, but hte problem does exists. Selected filter for transmit is 2.7 so thats not the problem. I did set the offset correct. -0.86. Can't figure out what is wrong. 
Any help? please

73 de Dick PA3FQA