[Elecraft] VFO step size

[Don Wilhelm]

Manuel,

Yes, set the configuration menu (while in SSB mode) parameter for VFO 
CRS to 1.0
Values of 0.1, 1.0, 2.5 and 5 are available for SSB.  VFO CRS is 
settable per mode.

After setting VFO CRS to 1.0,  pressing COURSE will toggle between 1.0 
kHz steps and 50 Hz steps, but the RATE and FINE buttons interact too 
giving a range of steps from 1 Hz to 1 kHz.

Once you make your selections, a bit of practice may be required to take 
advantage of all the capability available - but if you only want 1 kHz 
steps, all that is needed is to zero the low order digits and press 
course and you will traverse the band in even 1 kHz increments.

73,
Don W3FPR

Manuel Maseda wrote:
>  
> Hello,
>
> Can someone tell me if the K3 can be configured for a 1K VFO step size in
> SSB mode?
>
> Thanks,
> Manuel  W4SSB
>
>