[Elecraft] k3 firmware update.

[Brett Howard]

What mode are you in... Try using the auto notch when you're in SSB
mode...  The auto notch isn't there in CW mode because it can't really
tell the difference between a signal and a carrier with out making a lot
of assumptions that have high probability of being wrong...  


On Thu, 2008-07-10 at 07:46 +0200, Steef PA2A wrote:
> Iain, if there 's a K3 around I read webpages after a problem occurs hi!
> 
> I received #1184 last week with 2.10, probably beta?? I have a problem with 
> the notch, I can only toggle between OFF and MANUAL. The AUTO Notch is gone, 
> so I 'll have to do some firmware upload. Updating firmware and software is 
> not my favourite hobby....
> 
> 73 's Steef PA2A
> k2 #4654
> K3 #1184
> 
> ----- Original Message ----- 
> From: "Iain MacDonnell - K6IAM" <k6iam at dseven.org>
> To: "PAUL VANOVEREN" <nf8j at iserv.net>
> Cc: <Elecraft at mailman.qth.net>
> Sent: Thursday, July 10, 2008 3:14 AM
> Subject: Re: [Elecraft] k3 firmware update.
> >
> > PAUL VANOVEREN wrote on 07/ 9/08 06:03 PM:
> >> I am running the 2.02 version of the firmware, I believe there is a 
> >> released version 2.10, plus two new Beta releases.2.13  and 2.15. ...when 
> >> I go to the utility and it lists 2.02 on the K3 and 2.02 as the available 
> >> firmware for update...did I miss something ??
> >
> > According to:
> > http://www.elecraft.com/K3/k3_software.htm
> > 2.02 is the latest regular release.
> > If you want to go beta, follow:
> > http://www.elecraft.com/K3/k3_beta_release_instructions.htm
> >
> > Don't people read web pages around here? ;)
> >
> >     ~Iain
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com