[Elecraft] [K3] AGC

[Bob Cunnings]

Have you tried adjusting the CONFIG:AGC SLP parameter? I've set mine
to the maximum value, 15, for flattest AGC slope.

Bob NW8L

On Mon, Jul 7, 2008 at 8:13 AM, S Sacco <nn4x.steve at gmail.com> wrote:
> OK, now that I'm slowly getting my station rebuild to the point where
> I'm operating my K3 on a regular basis, I'm noticing that the AGC
> seems to be kind of sub-optimal.  There are large differences in audio
> volume when receiving different strength signals.   I have not been
> directly comparing the K3 to another receiver, but it keep surprising
> me (in a bad way).  On a couple of occasions, I had to rip off my
> headphones, because it was faster than reaching for the volume
> control.
>
> I seem to remember this being somewhat of an issue with earlier
> firmware versions, but I'm running 2.13 at this time.
>
> Is anyone else having this issue?
>
> 73,
> Steve NN4X
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>