[Elecraft] K3 OWNER’S MANUAL ERRATA

[Dave G4AON]

In the manual errata, the following mentions setting alternative filter 
"norm" settings. I think this has been mentioned previously, but mine 
doesn't seem to work as the manual errata suggests it should. The 
"-SAV-" appears but only for a split second, not allowing time to pick 
an alternate... I am using firmware 2.13, but haven't tried using the 
ALT filter settings previously.

 From the manual errata:

In addition to the K3's standard "NORM" values, you can save two of your 
own often-used filter setups in each
mode, and recall them using the NORM function. These are referred to as 
ALT1 and ALT2. To save a filter
setup, hold NORM until you see "<- SAV ->" (3 seconds), then rotate the 
knob left or right to save it as ALT1
or ALT2. (The arrows to the left and right of "SAV" are a reminder that 
you can rotate the knob left or right go
get to the "ALTernate" filter memories.) To recall, hold NORM until you 
see "<- NOR ->" (about 1/2 second),
then rotate the knob left or right to recall ALT1 or ALT2.

73 Dave