[Elecraft] K3 bail height

[Don Wilhelm]

That was going to be my suggestion until you beat me to it.  I was 
measuring the bail projection from the bottom of the feet and find it is 
1.75 inches, so a 0.5 inch thick piece of something (wood, plastic, 
paperback book, etc) under the front feet will produce the requested 
result.  That is too small to even consider a bail.

73,
Don W3FPR

S Sacco wrote:
> Keith -
>
> If you need it lowered that much, perhaps just put something under the
> front feet?
>
> 73,
> Steve NN4X
>
>
>   
>> Is there anyone out there interested in making a lower height bail, say 30
>> mm or 1.125" lower ??
>> As it stands it gives me a pain in the wrist tuning around, and I spend a
>> lot of time tuning around as here in Western Australia there certainly isn't
>>     
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com 
> Version: 8.0.138 / Virus Database: 270.4.5/1536 - Release Date: 7/5/2008 10:15 AM
>
>
>
>