[Elecraft] Split ops?

[Bob Serwy]

>From what I can tell, the UPBn; has not been implemented.  All you can do is
use up;  (for 10 Hz on the VFO A)  So you must use 200 up;'s (not
practical).  Then do a swt11; (to swap VFO's).  Also use ft1; to turn on
split.  (That is a number one.)  All swh13; does is toggle split on and off.

Bob Serwy - N9RS

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of G4ILO
Sent: Saturday, July 05, 2008 3:45 AM
To: elecraft at mailman.qth.net
Subject: RE: [Elecraft] Split ops?



Bob Serwy wrote:
> 
>  Yes there is.  I use it.
> 
> 'k31;swt13;swt13;k30;
> 
> 

OK. I mis-remembered the problem I had trying to get this to work.

I'm sending SWT13;SWT13;UPB4;UPB4;SWH13;

The two VFOs *are* being set to the same frequency and mode, and SPLIT is
being engaged, but VFO B is not being set 2KHz higher in frequency.

-----
Julian, G4ILO  K3 s/n: 222 K2 s/n: 392
G4ILO's Shack: www.g4ilo.com
KComm for K2/K3: www.g4ilo.com/kcomm.html
--
View this message in context:
http://www.nabble.com/Split-ops--tp18282086p18290111.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com