[Elecraft] RIT drops receive frequency 600 Hz HELP

[Don Wilhelm]

Dave,

On the K2 the way to center the RIT is to remove the knob, turn the 
shaft until the frequency difference between RIT ON and OFF is zero, 
then replace the knob with the pointer straight up (with care not to 
move the shaft when installing the knob).

73,
Don W3FPR

Djwilcox01 at aol.com wrote:
> I have a K2 that when I activate the RIT the received frequency drops 600  
> Hz, too low to tune back to the frequency of the VFO so the contact is  lost.  
> The only way that the RIT is on frequency with the VFO A is to turn  the RIT on 
> before beginning the contact.  Then everything is as it should  be…..  Any 
> suggestions?  I don’t see anything in the manual to explain  how to adjust the 
> RIT or center it on the VFO frequency.
>   
>