[Elecraft] Split ops?

[Bob Cunnings]

A second button press is now required to transfer the mode setting.
According to the release notes for version MCU 1.87 / DSP 1.69:

"* A->B SWITCH: 1st tap copies frequency only; 2nd tap within 2
seconds copies mode
and filter settings."

Bob NW8L

On Fri, Jul 4, 2008 at 9:56 AM, TMorton <cx7tt at 4email.net> wrote:
> When making the selection A>B then holding "Split" I notice that the mode
> stays where it last was...i.e., 14005 on A and 14180 on B; after A>B the B
> vfo is 14005 but remains in USB. I have looked thru the menu selections and
> can not find anything to have the modes match after doing A>B...have I
> missed something? If not, why not match freq and mode?
> 73
> Tom
> CX7TT
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>