[Elecraft] [K3] VFO fine-coarse tuning

[Bill W5WVO]

Let's say I'm tuning in FINE mode (to the 1 Hz digit) and the VFO says 50.135.056. If I then go to COARSE (to the 100 Hz digit), tune to a VFO indication of, say, 50.145.0, I intuitively expect that the actual VFO frequency will be 50.145.000 -- but it continues to carry the FINE 10s and 1s digits as an offset, so the actual frequency is 50.145.056, which is revealed by tapping the FINE button. This was probably an intentional design choice based on how other rigs work -- but it's not the way it seems like it should be, to me. Intuitively, it seems like if it says 50.145.0, it should be 50.145.000. Am I completely wrong-headed here? Comments?

Bill W5WVO