[Elecraft] k3 split/ delta F ?

[Brett Howard]

You can display the RIT offset using the disp menu feature while tech md
is on.  Then you can see the delta F in place of the VFO B.  The only
downside is that you have to use the small knob to set y our delta f.


On Thu, 2008-07-03 at 12:41 +0100, Stewart Baker wrote:
> As far as I can see it is not possible at present. It is fairly 
> high on my "should be quick to implement" wish list :-)
> 
> 73
> Stewart G3RXQ
> On Thu, 3 Jul 2008 04:22:59 -0700 (PDT), K3KO wrote:
> >
> > Anybody figure out if it is possible to display a delta F value 
> instead of
> > the actual VFO B frequency when in split?
> >
> > I've found that delta F is quite useful.  The actual frequency, 
> in practice,
> > is irrelevant in most split cases.
> >
> > Made a couple split contacts now on CW.  I like the fact that 
> bset stays on
> > so one can tune without having to hold it down continuously -- 
> like some
> > Kenwoods and ICOM's require.
> >
> > 73 de Brian/K3KO
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com