[Elecraft] K3 Firmware Update

[Don Nesbitt]

You must first enable the "Tech MD" menu item.  Config ==> Tech MD ==> use
VFO A to set it to ON ==> now use VFO B to locate TUN PWR ==> use VFO A to
set power ==> tap MEMU  -- Done.

Now when you Push and hold XMIT to get to the TUNE function, it will provide
the power you set - while there, you can now increase the power with the PWR
control to continue tuning up your amp at higher power.  When you are
finished, the next "TUNE" will be reset to the default that you set earlier.
Very handy!  73 es gud dxing -- Don N4HH K3 #83 

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Ehrlich
Sent: Tuesday, January 29, 2008 7:44 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Firmware Update

Have downloaded 1.65 / 1.52 and cannot find the Menu item for setting Tune 
power  (TUN PWR) as advertized in the release notes.

Don K7FJ
K3  195 

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com


-- 
No virus found in this incoming message.
Checked by AVG Free Edition. 
Version: 7.5.516 / Virus Database: 269.19.15/1249 - Release Date: 1/29/2008
9:51 AM