[Elecraft] K3 Firmware Update

[David Ferrington, M0XDF]

Great, there is only one other company that I have experience of, that
responds in this way, and that is DogPark Software who wrote MacLoggerDX.

Wonderful service Wayne.

Tune Power - greatly desired, thank you.

Mode Switch - really good button press saver :)

Installed via Mac software, no problem. Thanks for Mac K3 utility too :)

I still think my RTC runs slow by about 8 seconds over 48hrs, but the jury
is still out on that one and if it does, I doubt there is much you can do.


On 29/1/08 17:41, "wayne burdick" <n6kr at elecraft.com> sent:

> We've released a new revision of K3 firmware (both MCU and DSP). Please
> see the release notes below.


-- 
Patience serves as a protection against wrongs as clothes do against cold.
For if you put on more clothes as the cold increases, it will have no power
to hurt you.
So in like manner you must grow in patience when you meet with great wrongs,
and they will then be powerless to vex your mind.
-Leonardo da Vinci,  painter, engineer, musician, and scientist (1452-1519)