[Elecraft] K2 - K60XV Transverter Keying Output Questions

[AD6XY - Mike]

You might consider the multiple IO control output which will allow you to
control each transverter individually. 

If not, how about using the transverter TX (or RX) RF output to carry both
RF and control by imposing a DC voltage on it then and tapping it off in
each transverter? This is easy, just use an RF choke at each end. A good
enough RF choke is a 4.7K resistor and an RF bypass capacitor. The advantage
is fewer cables and if you use the TX line, you can't TX accidentally
without PTT control.

Regardless of what Q3 can or can not switch, it is always a good idea not to
switch the RF relays directly with the rig. It is much better to include a
switching transistor in the transverter and make the control signal low
current so you can protect it and the rig with a series resistor. One day,
by accident, you will connect the 12V supply directly to that line. The more
sure you are you won't, the more likely you will.

Mike


Steve Kavanagh wrote:
> 
> I am part way through the build of my K60XV and am
> trying to sort out how to interface it to my various
> existing homebrew and non-Elecraft transverters.  A
> couple of questions have arisen:
> 
> (1) I hope to use the transverter keyline output
> (J2-pin 2 on the K60XV), but there is no connector (or
> provision for one on the rear panel).  I have the
> K160RX installed and would like to be able to use it
> with either the QRP top cover or the KPA100 installed,
> so I can't really use any of the existing holes.  I am
> thinking of perhaps squeezing in a 3/32" jack just
> above and to the left (as seen from the rear) of the
> key jack.  Has anyone else come up with something
> better ?
> 
> (2) There appears to be no specification given in the
> K60XV manual for the maximum voltage and current that
> can be keyed by Q3.  I can probably figure it out from
> the 2N7000 data sheet, but I wonder if someone else
> has already done this or has some experience, in
> particular with transverters where the control input
> is connected directly to relay coils (such as Down
> East Microwave's transverters, for example) ?
> 
> 73,
> Steve VE3SMA
> 
> 
>       Be smarter than spam. See how smart SpamGuard is at giving junk
> email the boot with the All-new Yahoo! Mail.  Click on Options in Mail and
> switch to New Mail today or register for free at http://mail.yahoo.ca 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://www.nabble.com/K2---K60XV-Transverter-Keying-Output-Questions-tp15074071p15077111.html
Sent from the Elecraft mailing list archive at Nabble.com.