[Elecraft] K1: Band 2 (15M) low audio and a steady tone on one frequency

[MGFoster]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Greetings,

I have the 2 band (40M/15M) filter board, and the 15M receiver has very
poor reception and a very loud, steady tone on one frequency.  The
tone's bandwith is very narrow (about 2 Hz).  As soon as I construct the
RF probe I'll do some tests to determine why the reception is so poor.

I discovered this while installing the KAT1, which means I've installed
the connector at J2, thus removing the J2 jumper.  I was wondering if I
can temporarily insert a scrap component lead as a jumper in the
connector rather than destroy the connector to remove it & re-install
the jumper (while I test the Band 2 set-up without the KAT1)?

Also, has anyone any idea what may be the cause of the steady tone?  I
didn't see any mention in the list archive of a similar occurrence.  My
initial hunch is that it is a symptom of a short, possibly in the
crystal.

Thanks,
-- 
MGFoster:::mgf00 <at> earthlink <decimal-point> net
Oakland, CA (USA)

-----BEGIN PGP SIGNATURE-----
Version: PGP for Personal Privacy 5.0
Charset: noconv

iQA/AwUBR5NDsYechKqOuFEgEQKvwwCfaEipROZ9qTYQU5p2qIgRFtsf1fQAn2lX
U+FyuaqihmfJJiCkeaAi7E5a
=bvGh
-----END PGP SIGNATURE-----