[Elecraft] K3 Line-In for PSK31 not working

[Alan D. Wilcox]

Bob,
Think it was a simple matter of not adjusting the front panel MIC gain 
up when I went to Line-In setting. That's working, but the hassle continues.

Yes, I've got the latest 1.58, 1.48. At the moment I'm doing USB rather 
than data mode. I tried your suggestion for data mode with dataA, and it 
works the same also.

I was going to use VOX instead of a physical PTT, but that doesn't work 
well. I've adjusted gains but it insists on cycling on & off. Thought 
anti-VOX would fix, but it doesn't.

So I tried manual PTT with front panel button to transmit ... getting 
feedback somehow when I put the mic gain up to about 4 for even just 1 
bar ALC. Have power set to 5 watts.

Alan

-- 
Alan D. Wilcox, W3DVX
570-321-1516
http://WilcoxEngineering.com
Williamsport, PA 17701 

------------------------------------------------------------------------
rkayakr wrote:
> Alan
>
>   There were some problems with setting  "Line in" that have been cleared up
> with the last two firmware releases. The audio data modes now seem to work
> well, so I would ask the obvious questions:
>
> Do you have the latest firmware?
> Is mode set to "data"?
> Is data mode set to "data A"?
>
> With my computer audio output at a 50% setting a low K3 "Line IN" level of 3
> to 5 is sufficient.
>
>     Bob
>       KD8CGH
>
>