[Elecraft] New DSP-settings for 100 and 50Hz filters

[Dave G4AON]

Benny

If you switch the DSP by tapping "7" while in the filter menu and have 
50 or 100 Hz bandwidth there is quite a change in volume, however if you 
select the new default setting and rotate the width control all the 
settings are the same volume. What seems to happen is that now the 
50/100 Hz bandwidths jump in volume with the original "IIR on" setting, 
this didn't happen on the earlier software. Any thoughts Lyle?

73 Dave, G4AON
K3/100 #80
============

I loaded new wares 1.58 and 1.48.
 From Elecraft page this change was e.g. for 100 and 50Hz
DSP-filters.
My experience is, that both filter outputs were now
considerably attenuated.
Apparently I should install the old ones, which
is not recommended.
Anybody else have noticed a change?

Benny OH9NB