[Elecraft] ERR TXG Message es tnx

[Greg]

Carey.  You still need to do the TX Gain calibration.  That's what is
causing your error.  Page 46/47 of the manual.  Set power to 5W and hold
TUNE for a couple seconds on ALL BANDS.  Then, if you have the KPA3
installed, you need to do the same for ALL BANDS at 50W.

Let me know how it goes.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of H. Cary III
Sent: Tuesday, January 01, 2008 2:56 PM
To: elecraft at mailman.qth.net
Cc: Richard AD7FZ
Subject: [Elecraft] ERR TXG Message es tnx


The reference oscillator is now aligned with WWV - thanks to N0SS, W3FPR,
DJ7MGQ, and AD7FZ for responding so quickly - Tom talked me through it
thankfully.

I just did the Transmitter Gain calibration and get an error message - ERR
TXG - on all bands 160-6.  So after passing all the tests/checks during the
build, I seem to be alignment challenged  Even more frustrating is the
detail on the error message in the book says "it could affect one or two
bands (how about ALL?) and indicates a problem with band pass filter
alignment or one of the low pass filters.  Could one of the J-pin connectors
be the first place to look?

BTW, the good news is the receiver in my K3 is absolutely fantastic!  One
day, it'll all come together...

HNY & 73,
Cary, K4TM

K2-100 #5266
K3-100 #0178


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com