[Elecraft] K3 Undescribed socket.

[Dick Dievendorff]

The socket below the VFO dial is for an In-Circuit Debugger (ICD), used for
development and diagnostic purposes.

The RS-232 connector's DTR and RTS may be used for PTT and CW keying.  See
"PTT and Keying" on page 18 of the K3 Owner's reference manual. These lines
are input to the K3.

73 de Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Rich Lentz (KE0X)
Sent: Wednesday, February 27, 2008 2:25 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Undescribed socket.

What is the socket just below the "B" VFO dial on the bottom of the front
panel for?

 

Also, the RS232 jack has wires for RTS and DTR. Are these going to (can
they) be enabled to indicate "Squelch," etc.?

 

Rich

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com