[Elecraft] K2 AGC set

[Jack]

8v regulator output was 7.96v.

Thanks for the input guys. I'll finish the rig then set again.

cheers
Jack VK2CJC / MM0AXL
FISTS #9666 - CW QRP Club #753 - Elecraft K2 #6404
Mid North Coast Amateur Radio Group  www.mncarg.org
For MSN Messenger, use this emails return address

----- Original Message ----- 
From: "Don Wilhelm" <w3fpr at embarqmail.com>
To: "Jack" <vk2cjc at bigpond.com>
Cc: <elecraft at mailman.qth.net>
Sent: Thursday, February 28, 2008 3:16 AM
Subject: Re: [Elecraft] K2 AGC set


> Jack,
> 
> The cause of the low AGC Threshold is a low output from the 8 volt 
> regulator (Control Board U4)
> It will llikely not cause any problem at all if you simply set the 
> Threshold to max.  You could consider replacing the regulator if it 
> causes you concern.
> 
> 73,
> Don W3FPR