[Elecraft] K2 AGC

[Ken, KA0W]

Hello Jack!

I had about a 3.66 measurement as well. 

Figured with +/- 5% or 10% for error, etc. it is close enough.

Rig works fine, agc is doing it's thing. No complaints.

Ken, KA0W





----- Original Message ----
From: Jack <vk2cjc at bigpond.com>
To: elecraft at mailman.qth.net
Sent: Wednesday, February 27, 2008 12:32:22 AM
Subject: [Elecraft] K2 AGC

Setting the AGC threshold on my K2.

Adjusting R1 for 3.8 volts. But turned full up I can only achieve 3.666 
volts.

Is this a problem?

73
Jack VK2CJC / MM0AXL
FISTS #9666 - CW QRP Club #753 - Elecraft K2 #6404
Mid North Coast Amateur Radio Group  www.mncarg.org
For MSN Messenger, use this emails return address

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com