[Elecraft] software to load K3 memories,

[David Ferrington, M0XDF]

I have asked Don of DogPark software to consider adding K3 management to
MacMemoriesManager - another good reason to use a Mac :-)


On 23/02/2008 22:26, "Joe Stofko" <w1aiu at snet.net> sent:

> Hi Bill, 
> 
> I don't believe that there is. I would hope that
> the firmware gang (helloooo Lyle!) might address this
> in the future. The firmware load utility allows the user
> to save the K3 configuration so that it may be re-loaded
> if need be. BUT, there is no way to take the config file
> from the radio, edit it and then reload it.
-- 
The rung of a ladder was never meant to rest upon, but only to hold a man's
foot long enough to enable him to put the other somewhat higher.
-Thomas Henry Huxley, biologist and writer (1825-1995)