[Elecraft] K3 Output levels

[Matt Zilmer]

Harry,

You could develop a macro for this and use it in Command Mode with the
K3 Utility.  Command Mode is a very useful facility for this sort of
thing. 

Currently, power level sticks across bands and you'd have to reset it
by hand for 6m, or develop a standard set of macros to preset power
level, mode, Lo/Hi, etc. for given bands of interest.

matt, W6NIA
k3 # 24



On Sat, 23 Feb 2008 13:22:05 -0500, you wrote:

>Hi,
>
>I asked this question here before but no one anawered it. Maybe it was considered a dumb question. 
>
>Can the power output level of the K3/100 be individually programmed for different bands? For example to accomodate a low drive level 6M amplifier. I doubt it but thought I would ask as I cannot find anything in the literature on this. 
>
>It would be nice so that when you QSY'ed for a 6M band opening you would not over drive your 6M amp in the excitement.
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com