[Elecraft] K3 External Reference input

[Larry Putman]

Me too! 

The external Ref is very important to my QRSS QRPp very weak signal work to maintain my frequency tolerance to less then .1 hz.
I  am currently using an HP 3325A Synthesizer and HP Z3801A GPS Ref to put a stable and accurate signal on the air! Also have my RX340 referenced to the Z3801A Not having the external reference opt is a big setback!
I hope the ability to reduce the output power down to -15 dBm using the KXV3 is still  possible?

Larry Putman WB3ANQ

Pasadena, 
Maryland FM19rc
www.wb3anq.com

----- Original Message ----
From: Jerry T. Dowell <ai6l at sbcglobal.net>
To: Philip Theis <phil at k3tuf.com>; elecraft at mailman.qth.net
Sent: Saturday, February 23, 2008 9:17:39 AM
Subject: RE: [Elecraft] K3 External Reference input


You bet! That is one of the reasons I bought a K3.

Jerry   AI6L

-----Original Message-----
From: Philip Theis [mailto:phil at k3tuf.com] 
Sent: Friday, February 22, 2008 4:50 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 External Reference input

Is there interest among the group for the necessary parts to input a
disciplined 10MHz signal to control frequency?  We all know there is a place
holder on the back panel, but Gary just told me there were no plans.
In April Wayne said it was coming but the price hadn't been set.
Just wondering if anyone else out there has an interest like I do.
73,
Phil K3(352)TUF




      ____________________________________________________________________________________
Never miss a thing.  Make Yahoo your home page. 
http://www.yahoo.com/r/hs