[Elecraft] K3 antenna jacks

[Robert Tellefsen]

Thanks for the post on the BNCs, Ken.
I was just looking for that info.
73, Bob N6WG

----- Original Message ----- 
From: "Ken Kopp" <k0pp at rfwave.net>
To: "Jim Miller" <jim at jtmiller.com>; <elecraft at mailman.qth.net>
Sent: Thursday, February 21, 2008 6:06 AM
Subject: Re: [Elecraft] K3 antenna jacks


> Yes Jim, Type N's will work fine.  The pigtails are just 
> stranded wire about 3" or so long with a male pin that
> plugs into the antenna tuner module.
> 
> However, I've used BNC's on mine.  Oak Hills Research
> sells a 2-pack with beautiful adapter plates for $7.50.  His
> part number is OP-SB2.
> 
> 73! Ken Kopp - K0PP
>        K3 #56
>        K2 #5665
>        ElecraftCovers at rfwave.net
>        or
>        k0pp at rfwave.net
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com