[Elecraft] K3 with Microkeyer2

[Greg - AB7R]

I have been doing this with no problems using an MK2R+.  It does load a bit slower than a native COM port, but its 
still fine.  I changed the radio port as Joe mentioned and just saved that as one of the presets "K3 Firmware".  So I 
just click the preset before uploading the FW.  

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065
K3#0009

On Thu Feb 21  7:19 , "Joe Subich, W4TV"  sent:

>
>> Can the Microkeyer II USB interface be used to upload 
>> firmware upgrades with the K3?
>
>Yes.  However you must first open Router and set the Radio 
>type (Radio Port | Set) to "None" or check "Disable router 
>queries" to prevent Router from trying to poll the radio 
>during the upload.  
>
>73, 
>
>   ... Joe Subich, W4TV 
>       microHAM America 
>       http://www.microHAM-USA.com 
>       http://groups.yahoo.com/group/microHAM 
>       support at microham.com 
> 
>
>
>
>
>> -----Original Message-----
>> From: elecraft-bounces at mailman.qth.net 
>> [elecraft-bounces at mailman.qth.net','','','')">elecraft-bounces at mailman.qth.net] On Behalf Of John Gaynard
>> Sent: Thursday, February 21, 2008 12:43 AM
>> To: elecraft at mailman.qth.net
>> Subject: [Elecraft] K3 with Microkeyer2
>> 
>> 
>> Can the Microkeyer II USB interface be used to upload 
>> firmware upgrades with
>> the K3?
>> 
>> John K8WDN
>> K3  S/N #157
>> 
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com