[Elecraft] K2 just quit working.

[Don Wilhelm]

Gary,

The first order of business would be to look for an unsoldered 
connection.  The likely places are the Control Board and the Front Panel 
board.  Sorry, but I cannot speculate further without additional 
information.  If you do not find that elusive solder connection, then 
you should begin troubleshooting with the DC voltage measurements - 
again, the Control Board and the Front Panel Board are the initial prime 
suspects.

73,
Don W3FPR

Gary Krause wrote:
> My K2 #6113 just quit working.  I was listening to the 40 meter band 
> and all of a sudden no signal, and no audio.  The display works but, 
> the frequency is frozen.  The only other control that works is the 
> power level.  None of the buttons work and the frequency can't be 
> changed.  There are no error messages on power up and it powers up as 
> normal with "Elecraft" and then goes to the frequency.
> I'm getting ready to take out the control board and have a look.  Any 
> help would be appreciated.
>
> I recently had a problem with SSB transmitting just stopping so, I may 
> be related.
>